How to competently stick wallpaper on the wall with whitewashing
Walls of wallpaper involves preparatory work. If there is whitewashing on the surface, then the preparation is carried out according to certain rules. If everything is done correctly, then the wallpaper will look perfect and last for a long time. Before performing the finish using wallpaper, the surface of the walls should be properly prepared for “cosmetics”. Typically, the walls are carefully eliminated from the old venerable layer, align to the perfect state and are well cleaned of all kinds of pollution. But, in the old days, whitewashing was often used, so it is not always possible to remove it. In this case, experts advise sticking wallpaper directly over the whitewash. If the whitewashing has a “deplorable” appearance, then it should be completely removed from the walls. This can be done through a brush or piece of tulle. Whitewashing is pre -soaked with water, and easily removed from the wall. How to prepare a wall with whitewashing for wallpapers before gluing wallpaper for whitewashing, you need to correctly prepare the surface. First of all, you need to make sure that the whitewash layer has high quality, that is, without cracks, chips and exfoliations. But, you don’t need to take risks, because lime can absorb an adhesive for wallpaper and fall off at the most inopportune moment. It is advisable to glue the trial wallpaper and wait a while, if nothing happens and the wallpaper remains in place, then you can continue repair measures. The wall must be primed with an acrylic composition so that the surface is soaked as possible. When the primer dries, another layer is laid out. Further, the adhesive composition for wallpapers is diluted with water (2 to 10) and applied to the wall as a third primer layer. After the walls are completely dry, you can start finishing work and glue the wallpaper. Basic rules for pasting wall wallpapers to glue the wallpaper for whitewashing? First, get acquainted with the important rules of this procedure.1. The wallpaper must be prepared in advance: remove measurements, cut the canvases. Excessive parts of the finish can be removed using a blade.2. Next, dilute the special glue for wallpaper in accordance with the instructions that are on the package and begin to glue the finishing layer.3. Previously, the wallpaper must be impregnated with glue, if this is indicated in the instructions.4. The adhesive solution is applied to the surface from the middle to the edges of the cloth. The walls are also lubricated with glue.5. The gluing of the surface, as a rule, begins from window to door, taking into account the angle of light falling.6. It is recommended to smooth the canvases with a piece of soft fabric or with a special roller, moving from top to bottom and from the center to the sides.