Technological features of mounting frames from metal profiles for drywall are such that, sometimes it is necessary to carefully select the acceptable material of components of elements.
In a primitive version, frames from wooden racks or rails can be used, but this design has its own deficiencies, including both the inconvenience of mounting and certain nuances of operation. Although the rack profile can be mounted in conjunction with wooden structural elements is still better to mount the design, excluding this technological feature. Frame mount begins with the direction of the structure, which must first be set to mark on the surface of the guide and rack profile in the places of their future fixation.
The start of mounting the structure.
The installation of the structure is carried out according to the places of the marking, so the direction of the design requires the use of the guide profile of the fixed one at a distance according to the marked places using dowels of the desired depth and size. The fact that the surface on which the guide profile is attached is required to be even in order to avoid deformation of the profile, which would negatively affect the quality of subsequent mounting and lining. At the corners of the profile joint, they are connected by a specialized tool. The guide profile under the design of the pie is attached along the ceiling and lower part of the surface, as well as the walls.
Continuation of installation of the structure.
When mounting piers, as a rule, two third -party designs of the frame are required, which is not a problem, provided it is necessary. So there are different technological solutions to the device of the pieces of paper due to the variety of operational conditions. But if we talk about the simple device of pieces of paper with the possibility of saving space, then in this context the use of a rack profile involves the connection of two relative to each other and the installation according to the guide. Strike, according to the design, the profile is inserted into the groove of the guide and fixed at a distance according to the requirements – this is up to sixty centimeters. In this case, the marking of the frame is carried out from the middle of the profile, as this contributes to the docking of the edges of the gypsocarone sheet.
Hypsum plasterboard casing.
The trick of the installation of surfaces using drywall sheets is the following points. So to determine the acceptability of the characteristics of the sheets that are different, the characteristics of the conditions under which this design and its surface will be operated are taken into account. The moisture resistance of drywall, for example, allows it to apply on the surface with the requirements of increased waterproofing and the like. But in any case, the frame is sheathed in a checkerboard pattern, unless of course the area of the structure exceeds the height of the sheets. The joints of the gypsum sheets are attached in the middle of a rack profile. If you need to cut the sheet, then this is done using a knife on cardboard or what other tools, for example, a linear wiper. In places of openings for doors, the cut profile is attached to the required height and an additional rack element is installed on the remainder of the height, according to which it is easy to join the drywall sheets. If the rack necessary profile is sheathed in the middle, then the guide requires a sheathing along its edge, when sheathing, self -cutting screws of the corresponding size are used, it is determined that the width of the gypsum sheet.